70332 - Up to April 04

1. Unclip the gaiter panel around the gear lever. Lift up the front section and slide forwards. Set aside so that you can access the ashtray. Remove the two silver retaining clips securing the lower section of fascia

2. Unclip the ashtray assembly by levering the plastic supports towards you.
Lift out the tray and set aside.

3.  In the corner of each air vent locate a plastic tab, the lower of two: simultaneously rotate the vent upwards and slide the tab to the right with a screw driver.
This will rotate the vents further than their normal operation and enable access to torx screws in the lower section of each vent. Remove these.

4. Repeat the process, but rotate the air vents downwards in order to locate four plastic retaining clips in the upper sections. Depress these with screwdriver to release the assembly.

5. Lift the assembly out and set aside.

6. Locate the bracket with the Torx 20 screw in the upper left corner of the climate control recess.

7. Refit all components in reverse.

SUITABLE FOR VEHICLES FITTED WITH SAT NAV

70332 - April 04>

1. Unclip the gear shift surrounds.

2. Remove the ashtray.

3. Remove the two Torx 15 screws beneath the ACC panel.

4. Unclip the upper section of the ACC trim.

5. Remove the two Torx 15 screws in the recess beneath the radio/screen.

6. Lever out the housing sufficiently to align the bracket with the left hand screw hole.

7. Refit the screws and panels.